Hello Guest it is March 28, 2024, 08:01:36 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - aluplastvz

Pages: 1 2 3 4 5 »
1
Modbus / Re: is it possible to call Modbus commands with G or M Codes?
« on: October 20, 2020, 01:52:03 AM »
Sorry my mistake

3
Modbus / Re: is it possible to call Modbus commands with G or M Codes?
« on: October 19, 2020, 02:02:20 AM »
хттпс://ввв.иоутубе.цом/ватцх?в=Сво1ЈВ9зТиг



I did it and it works nicely

4
General Mach Discussion / Re: Error Art Code 9991
« on: October 17, 2020, 01:39:44 PM »
You may not believe I had a problem with the same error and accidentally discovered that the cause was a bad mouse connector when you move or turn off the mouse MACH3 freezes but only with one type of mouse and all the others worked normally
Maybe help someone
Hello

5
Modbus / Re: FATEK Modbus
« on: April 12, 2020, 06:08:21 PM »

6
Modbus / Re: FATEK Modbus
« on: April 12, 2020, 05:35:52 PM »

7
VB and the development of wizards / Re: horizontal bolt pattern
« on: September 14, 2016, 04:03:21 PM »
I've experimented a little bit but I have not found a final solution but if someone has a solution to help
greeting

8
VB and the development of wizards / horizontal bolt pattern
« on: September 13, 2016, 03:57:00 PM »
whether someone has an idea for a macro script how to do layout for horizontal drilling this is for vertical drilling but should not let the z-10 that, for example, repeated 10 times in the same movement naprimet y30 x0, x0 y0 at a distance of 50 mm.
greeting

9
MACH TOOL BOX / Re: Gcode File section script
« on: March 08, 2016, 03:56:21 PM »
extra   

greeting

10
General Mach Discussion / Tangenta to angle 0/90 =on/off output
« on: February 25, 2016, 03:26:08 PM »
have solutions that tangent works as a pneumatic cylinder

G0 x0y0
M3
G1 x200 y0 ( output3 on )
M5
G0x300 y300
M3
G1 x300 y0 (output 3 off )
M5
M30

Pages: 1 2 3 4 5 »