Hello Guest it is March 18, 2024, 10:02:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Klingbeil

Pages: 1
1
General Mach Discussion / Re: Mach3 and Roland Mills
« on: November 24, 2010, 03:43:13 PM »
bugger...

well, thank you for your help :)

2
General Mach Discussion / Re: Mach3 and Roland Mills
« on: November 24, 2010, 03:32:30 PM »
thanks for the response.  i'm not sure if it's considered blasphemous, but would you happen to know of some controller software that operates via USB since Mach3 won't work?

3
General Mach Discussion / Mach3 and Roland Mills
« on: November 24, 2010, 02:44:19 PM »
i've got a Roland MDX-540SA and it's connection is USB only.  it is also recognized by the system as a printer.

has anyone tried using Mach3 with one of Roland's new systems?  i've fiddled around with the Mach3 demo and i can't seem to find any way of redirecting it to the USB connection.  i realize in the requirements section it says:

"if using the Mach3 Parallel Port Driver - laptops are not supported because the power saving features of the chipsets disrupt the pulse stream, PCMCIA and USB parallel adaptors will *not* work."

but i assumed that meant that it would not work through USB to parallel adapters or do i have that all wrong?

Pages: 1