Hello Guest it is May 17, 2021, 12:53:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - msimpson

Pages: 1
General Mach Discussion / Mach 3 slave tweaking question
« on: February 12, 2012, 01:08:31 PM »
I am setup to have A axis slaved to Y axis. I was wandering if there was a way to tweak the A axis by its self? (Even while it is still slaved to Y)

General Mach Discussion / Rounded corners with low acceleration
« on: November 19, 2010, 05:42:17 AM »
If I set my accelration down low I get a smooth operation but I also get rounded corrners.   Its like Mach3 starts the next line of Gcode be for the thing as stopped.  Am I missing something?

Pages: 1