Messages

1

Galil / Re: Pin Numbers for the AUX connector on 2040

« on: December 27, 2010, 07:58:33 PM »

thanks

next question
where in mach do i map the inputs and outputs for the extended I/O on the galil 2040.

I am actually converting from a Grex over to Galil on a bridgeport interact mill
on the Grex I had 26 inputs and 12 output LED's on the panel..

thanks

2

Galil / Pin Numbers for the AUX connector on 2040

« on: December 27, 2010, 05:53:26 PM »

HI

need help

trying to setup an MPG using the Aux X axis.
I have told Galili plugin - MPG#1 axis = X(A) and checked box for Use Aux, Encdr

in Mach the setting for MPG are = MPG#1 is enabled,  A-Port is 1 ,  A-Pin is , B-Port is 1 and  B-pin is

Thanks

3

Galil / Multi-pull Galil controllers

« on: December 13, 2010, 06:45:56 PM »

HI

Could I use a galil DMC-2040 and DMC-2020 together on Mach 3
Serial cable going from PC to the DMC-2040 and and then chaining onto the the DMC-2020

IF yes then do I do the same with the USB cable?

thanks
Musky