Messages

1

General Mach Discussion / Re: Setup question

« on: November 16, 2010, 11:13:57 AM »

Turning off MaxCL did the trick.

Thanks, Jim

2

General Mach Discussion / Re: Setup question

« on: November 15, 2010, 06:27:58 PM »

Thanks for the quick reply. I'll give it a try tomorrow at work and let you know.

-Jim

3

General Mach Discussion / Re: Setup question

« on: November 15, 2010, 06:11:51 PM »

Here are the mill and plasma profiles.

4

General Mach Discussion / Re: Setup question

« on: November 15, 2010, 06:56:37 AM »

The port address is the same as are the pin assignments. The estop is not setup now so is set as active low which is the same as it was set in the mill version. The DRO values do change while jogging while the stepper motor just sits there. It is energized however as it will not turn by hand.

5

General Mach Discussion / Setup question

« on: November 14, 2010, 08:50:29 PM »

Hi,

When I use Mach3Mill, I can jog my motors fine. However, when I switch to Plasma with seemingly the same setup, I can't get the motors to budge. Any Ideas?

Thanks