Hello Guest it is March 28, 2024, 06:20:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ReCar

Pages: 1
1
Brains Development / Change G Code
« on: September 22, 2009, 06:24:32 PM »
Hi, I use the Mach3 in a manipulator for welding and need it receives information from an external system and change the G code that are running. It is possible to be done through the MachBrain?

I thought about making a single file .txt with different blocks of G code and changes them according to the entry in paralele port. What do you think?

2
General Mach Discussion / Re: New PlugIn
« on: February 05, 2007, 04:48:09 AM »
Hi,
 
I would like to capture four axis with JCode, and to transfer "Rec Point" to external button. Is possible?
 
Thanks.
Renon

Pages: 1