Guest
Show Posts
1
General Mach Discussion / Re: problem with parallel port
« on: November 12, 2010, 04:12:45 PM »
Hi there!
I'm having the same problem. Mach3 seems to work correctly but the driver does not receive any signal from the parallel port. The parallel port acts as if the address is not the right one.
I've tried different addresses from the parallel port's properties but nothing happens. Is there any way to discover the correct address of the port other than resourses tab in properties?
I'm having the same problem. Mach3 seems to work correctly but the driver does not receive any signal from the parallel port. The parallel port acts as if the address is not the right one.
I've tried different addresses from the parallel port's properties but nothing happens. Is there any way to discover the correct address of the port other than resourses tab in properties?