1
FAQs / Re: Pulsing too fast
« on: November 11, 2010, 06:24:21 PM »
Hello fellow machinists.
I'm in London England.
I too ran the 'check config' and it said that the kernel speed was higher than required by the motor tuning. I looked for the kernel speed and it is set, as suggested by my supplier (ZealCNC), at 75khz but the 25khz mode is suggested by the sooftware.
I ran the DriverTest and it says: '25khz' but it also says 'pulsing too fast'
Any clues?
I'm in London England.
I too ran the 'check config' and it said that the kernel speed was higher than required by the motor tuning. I looked for the kernel speed and it is set, as suggested by my supplier (ZealCNC), at 75khz but the 25khz mode is suggested by the sooftware.
I ran the DriverTest and it says: '25khz' but it also says 'pulsing too fast'
Any clues?