Hello Guest it is April 18, 2021, 03:07:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - gurasha

Pages: 1
Mach3 and G-Rex / Re: Setting up new pci card in mach3
« on: November 12, 2010, 02:01:39 PM »
almost same problem just one thing. I wok on Xp. got any solutions?

General Mach Discussion / problem with parallel port
« on: November 12, 2010, 02:00:28 PM »
got a new computer wich has no integrated parallel port on it so I instaled paralell port card to connect computer to driver but.. mach3 has no control over card. the adress the it shows in properties is EC00. can u tell me what is the problem?

General Mach Discussion / NEWBEE problem with tb6560 and mach3
« on: November 07, 2010, 04:03:50 AM »
hello to everybody

just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready  have run drivertest. can u give me any suggestions?

Pages: 1