2
« on: May 05, 2011, 08:29:29 PM »
Hello,
I am semi-retired which just means I still need the money but I don't want to work hard for it.
I have a couple of lasers I use for marking and welding. I was driving the welder with an old MaxNC controller/driver running in DOS. That computer finally gave up the ghost and I am looking to driving the same controller with Mach3.
I loaded the software and it seems to check out but I get no indication of position change on the axis read outs when I run a test program. I can see it stepping through the G-code lines.
This is probably something simple but not obvious to me. Any help would be appreciated.
Tony