Messages

1

General Mach Discussion / Re: Mach XML Reader

« on: December 31, 2018, 02:49:21 PM »

Thanks! This tool was very helpful in recovering from a crashed computer.

2

General Mach Discussion / Re: How to set coordinates to specific values?

« on: July 20, 2015, 02:05:25 PM »

How do you switch from machine to work coordinates?

3

General Mach Discussion / Re: How to set coordinates to specific values?

« on: July 16, 2015, 10:32:50 AM »

I thought that was how to do it, but it will not let me input numbers. I tried on the program run page and the diagnostic page but not dice. For example, I click on the x value, it highlights, i type numbers, hit enter, but the numbers go right back to where they were. I'm using the candcnc DTHC IV ether-cut screen.

4

General Mach Discussion / How to set coordinates to specific values?

« on: July 15, 2015, 04:34:21 PM »

I have a plasma table with candcnc gear and I ran into a problem. I had to stop during a cut and restart the computer, but I was able to write down the x,y where the machine stopped. When I was ready to start again, I wanted to input the previous numbers, but I could not figure out how. I ended up zeroing it where it was, then i jogged to the negative of my coordinates and re-zeroed. This got the job done, but it would have been much easier to just type in the coordinates. How do I do that?