1
Galil / Re: galil thc
« on: October 19, 2010, 06:31:51 PM »
I have recently installed Mach3 + Galil DMC-1830 on a large plasma cutting machine. I was planning to use the CandCNC torch height controller (LCTHC). I purchased the unit without consulting Tom at CandCNC and learned during the installation that it wouldn't work with the Galil board.The Mach3 + Galil combination is excellent. Would it be possible to run a thread(subroutine) on the Galil dedicated to reading two inputs - the torch up and torch down inputs - to modify the torch position?
Steve Hasbury
Steve Hasbury