1
General Mach Discussion / Help with Estimate Program Run Time
« on: May 26, 2011, 05:18:48 PM »
Hi I'm a newbie here. I have a Taig CNC and Rhicam. I set Feed Rate at 800mm/min with 10k RPM on Spindle.
According on calculation on Rhino Cam, running time should 1 hour 28 min. However, when I upload to Mach3 Estimate Program Run time is 6 hour 30min instead.
What is wrong here?
According on calculation on Rhino Cam, running time should 1 hour 28 min. However, when I upload to Mach3 Estimate Program Run time is 6 hour 30min instead.
What is wrong here?