Messages

1

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 06:52:32 PM »

and thanks again

2

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 06:22:35 PM »

the bolts in headstock was closed to strong i open them alitle and now ok

3

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 06:02:10 PM »

i look the bolts to strong

4

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 05:33:48 PM »

ok first of all  greeeeeeeeeeeeeeeeeeeeeeeaaaaaaaaaaaaaaaaaaaaaaaaat thanks for this moment everything works correct hopes its stay like this and sometime big problem for somebody its simple solution to enother thank you my frend and if it no big problem ijust want to know you name to know you personal and again great thanks to you

5

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:54:59 PM »

i go to check

6

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:49:35 PM »

the z move like clock tik tak and go 1 up

7

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:38:48 PM »

no like other motors when it going down its just fly normaly but up its nitgmare

8

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:35:07 PM »

i try this but when i off the z limit switch the z axis dont move corectly move cuple steps and stop after this i see in monitor the z ups but not move in the mill

9

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:28:59 PM »

 i just try jog the z axis up + and every cuple lines its stop limit switches trigered this is the mesage i see down of the screen nad yes the limit switches just crazy me i real dont know what to do other axis just work fine

10

General Mach Discussion / Re: TAIG 3000 DSLS

« on: September 26, 2010, 04:23:07 PM »

no its not working i have this problem only in z++ in z--all ok