Messages

1

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 18, 2010, 10:07:17 AM »

Hi Mike, are you using analog joysticks in your gamepad to control milling machine ?

2

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 10, 2010, 12:34:57 PM »

So as I see no one has such ridiculous problems like me:)
Mike if you have time take a look at your personal message

3

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 09, 2010, 04:11:14 PM »

Maybe someone have configuration files to handle DSPMC and gamepad?

4

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 09, 2010, 03:43:23 AM »

Thank you for your reply Mike,
Maybe some plugin to handle joypad work, as you say mike "I did nothing special to make keygrabber and the gamepad work."
I do not know what I'm doing wrong

5

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 08, 2010, 05:36:32 PM »

I have one MPG and it works with DSPMC but I have no idea how to set up another MPG to make it work
Priority for me is that both axes were supported at the same time (X and Y), the best solution for me is to run the gamepad because it is more practical.
Unfortunately, I do not know what I'm doing wrong, when I use the LPT axis works but when I use DSPMC I have no control over the axes even though the same settings in keygrabber
Thanks for any help and sorry for my English

6

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 08, 2010, 12:28:51 PM »

Perhaps is another way without buying modules like PoKeys?
DSPMC actually have three pairs of inputs for connecting MPG, or only one is supported?
Maybe someone knows why when DSPMC is connected gamepad don't supported axis?

7

dspMC/IP Motion Controller / Re: More than one MPG ?

« on: September 08, 2010, 09:58:29 AM »

Thank you for your reply Mike,
Normally when I use LPT I have no problem with keygrabber but when I use DSPMC I can't moving axes but I can move things like: feed rate or spindle speed.

8

dspMC/IP Motion Controller / More than one MPG ?

« on: September 08, 2010, 07:01:33 AM »

Hello, can someone please tell me how can I use two MPG, or maybe someone knows how to configure the pad with KEYGRABBER or plugin?
Because I have to control two axes.

Dawid