Hello Guest it is March 29, 2024, 07:28:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rob111

Pages: 1
1
General Mach Discussion / Re: Bug in Version Update?
« on: May 11, 2011, 10:31:12 AM »
I notice another issue when I run a test program. When I turn 3" diameter stock, and the feed rate is 100 inches / min., the stock does not go a full 360 before stopping and turning back to zero. It stops short both ways. When I adjust the feed rate down to 50% , the rotation is more corrected and comes closer to 360 and 0.  I have no idea what to do about this.  Any suggestions?  Rob

2
General Mach Discussion / Re: Bug in Version Update?
« on: May 11, 2011, 09:37:34 AM »
Thanks, Hood. That was the problem. I have been pouring over my Vectric Aspire software and am not giving Mach 3 enough attention. I want to set up offsets for the rotary touch plate I'm making and will be spending more time on the forum.  By the way, my father was born in Dumbarton, Scotland and immigrated to NY.

3
General Mach Discussion / Re: Bug in Version Update?
« on: May 10, 2011, 10:21:04 PM »
I'm having problems setting up the rotation radius dro for the feed rate compensation. I cannot enter any values , like .001 for the rotation radius. Mach 3 will not allow any values other than 0.0.   What do I do?  Rob

Pages: 1