Hello Guest it is March 28, 2024, 05:44:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ayprens

Pages: 1
1
General Mach Discussion / Re: not circle that is a polygon
« on: August 26, 2010, 07:43:44 AM »
no. i have my own license. i purchased myself from scott nichols.
do you think my license is fake. this is a very big problem.

2
General Mach Discussion / Re: not circle that is a polygon
« on: August 26, 2010, 05:15:30 AM »
I am using 3.042.040 version of mach with license.
i dont think so my problem about license.
i count 40 segmented lines at one circle.

3
General Mach Discussion / Re: not circle that is a polygon
« on: August 25, 2010, 07:38:07 AM »
i know perfect circle imposible for x.y.z machines.  But my surface is very bad. i am using servo system. My mechanical equipment is very good.
i think my mach3 setting is wrong or circular interpolation is not enough. i send my setting file.

4
General Mach Discussion / not circle that is a polygon
« on: August 25, 2010, 06:12:32 AM »
i want to make circle cutting but i failed. try all of CV settings.

g code example:
F400
G00 Z10
G00 X7.5 Y0
G00 Z1
G01 Z-0.5 F50
G02 X7.5 Y0 I-7.5 J0 F400
G01 Z-1 F50
G02 X7.5 Y0 I-7.5 J0 F400

i zoom toolpath screen. this is not a perfect circle. it is segmented. When i was cutting a circle, surface is choppy.




Pages: 1