Hello Guest it is December 01, 2021, 02:46:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - efebur

Pages: 1
1
General Mach Discussion / Z axis homing problem
« on: October 27, 2012, 08:35:38 AM »
Hood, thank you so much.. :)

2
General Mach Discussion / Z axis homing problem
« on: October 23, 2012, 06:05:48 AM »
I restart my computer, reload gcode and start. For try machine cords. And that's working now. Nonsense I can't understand anything. Everything is working now after restart os. :/

3
General Mach Discussion / Mach 3 and Sheetcam under linux?
« on: October 23, 2012, 05:46:26 AM »
Ok. Thank you.

4
General Mach Discussion / Mach 3 and Sheetcam under linux?
« on: October 22, 2012, 06:11:51 PM »
Can I use Mach 3 and Sheetcam on any linux os like mac osx or ubuntu or pardus?

5
General Mach Discussion / Z axis homing problem
« on: October 22, 2012, 06:06:49 PM »
No it isnt ref all button. That is goto zero button. For all axises. But i ll check machine cords one more.

6
General Mach Discussion / Re: Z axis homing problem
« on: October 22, 2012, 01:29:53 AM »
(thanks for reply)

7
General Mach Discussion / Re: Z axis homing problem
« on: October 22, 2012, 01:29:10 AM »
When I am press the go home button, Z axis isn't going to zero. Going up.  Which setting is wrong?

8
General Mach Discussion / Z axis homing problem
« on: October 21, 2012, 01:37:15 PM »
Hello

I am using cnc plasma and router. And that tables have one controll system so drivers pc etc.

I wasn't using my router for a long time. And I need that today. But I have a some problems. I can't found my mach 3 mill folder. And I reset all of settings. I set all of settings but when I press the go to zero button, Z axis doesn't going to zero. Going to up when pressing the limit switch. I loaded the G-code, pressed the cycle start but that didn't go real measurements. Going to smaller than 40 percent draw and drilling that.

So I ll wait replies. What can be wrong? ???

Note: I am sorry for my bad english.  :(

9
Flash Screens / Make a Flash Screen
« on: August 23, 2010, 12:22:34 PM »
I want to make flash screen

But I don't know

how make flash screen and what program use make flash screen

please explain this to me in detail

thanks

Pages: 1