Hello Guest it is March 29, 2024, 07:34:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rrrevels

Pages: 1
1
General Mach Discussion / Re: Locked Feed rate
« on: January 19, 2012, 08:37:22 AM »
I never heard back from the friend and finally had a chance to go see him Monday.  His problem was simply a bad feed rate in the cut file.  I edited the file and told him how to correct it in his source and everything is fine.  His inexperience caused a lot of unnecessary questions.

Russ

2
General Mach Discussion / Re: Locked Feed rate
« on: January 03, 2012, 10:10:31 PM »
I am waiting for a copy of the xml file and will post.  Hopefully tomorrow.

Thanks,
Russ

3
General Mach Discussion / Locked Feed rate
« on: January 02, 2012, 09:53:59 PM »
A friend contacted me about a problem he created in Mach3.  He said his Feed Rate is locked at 2.3 and the over ride button flashes.  I have tried to come up with ideas of what may have happened but am at a loss. 

Anyone have any ideas of where to look?

Thanks,
Russ

Pages: 1