Hello Guest it is March 29, 2024, 05:36:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - patrick

Pages: 1
1
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 08:00:45 PM »
A few clumps of hair later I found that the device driver for the parallel card I have was not functioning. I don't see how the mach Update would cause that, but the events happened at the same time.  Reinstalling the card driver allowed the The pulse test now operates successfully.
  
 I deleted my licence though and I can't find the email it came in. Is there a way to retrieve it from art soft?
 patrick

 disregard I found the licence in the trash.
 Now I have to go though and tune everything again. It is update to the current lock down though :)
 patrick
 

2
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 06:47:42 PM »
Older versions are giving me the same notice.  I uninstalled everything and reinstalled. I just keep getting the same notice. It had been working fine for over a year. I had updated before without issue. This time however something seems to have changed that is preventing that driver from being installed.
 patrick

3
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 02:53:37 PM »
I appreciate the the assistance thank you.
 I am not sure I can find the older version, but I will look. Is there an archive of older lockdowns?
 patrick

4
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 05:02:02 AM »
No pulsing driver in list. And the fresh copy gives the same result.    Windows is 32bit
 patrick

5
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 03:50:42 AM »
 365 day work week is standard for me too  ;)
 I repeated the install three times now, ran the test each time as well. same results.
 patrick
   

6
General Mach Discussion / Re: "No Driver Sensed"
« on: July 18, 2010, 03:39:49 AM »
Driver test gives me the same notice I get during install. No driver sensed....
 Thanks for weekend response
 patrick

7
General Mach Discussion / "No Driver Sensed"
« on: July 18, 2010, 01:48:44 AM »
I Updated from version 2 to the current lock down. I got the "No driver sensed installed. Run driver test"  I was logged in as admin and I checked the box for driver install.
 I am running xp sp3 on a intel quad core desktop. I was not having any issue until I updated. Is there a way to manually install the driver?
 Thanks,
 patrick

Pages: 1