Messages

1

General Mach Discussion / Re: how to test mach3 with parallel port pin?

« on: July 17, 2010, 04:44:12 AM »

i don't know Where the diagnostics page shows outputs on the  step and direction pins? I just saw 8 led-on ( at port 1 pin current state, that are ground). mach3 to run when it is just 8 LED scroll on while Dro

2

General Mach Discussion / Re: how to test mach3 with parallel port pin?

« on: July 17, 2010, 04:13:11 AM »

I'm connect to led with LPT gate ( gate printer).
I don't know signal out put of mach to LPT gate. You can answer the question to me.
thanks

3

General Mach Discussion / how to test mach3 with parallel port pin?

« on: July 16, 2010, 10:45:44 PM »

hi, Im khai, i have question. How to test mach3 with parallel port pin. i have parallel port with LED. Mach3 run but i don't see led light.