Hello Guest it is March 29, 2024, 03:54:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - n1k86123

Pages: 1
1
I have a new router that uses a G540 and I would like to use a C19 speed controller ( http://www.cnc4pc.com/Store/osc/product_info.php?cPath=25&products_id=155 )  from CNC4PC.com to control my Bosch 1617 spindle.  Has anyone done this and do you know the proper settings in Mach 3?  I have G540 position 6 (Pin 1) hooked to the Enable 1 spot, the VFD ground, VFD output and VFD +10VDC hooked up to the proper place on the c19.  I have the Dip switchs set to 50 HZ and 0-10VDC control.  I have Spindle Enabled in Motor Outputs and 14 as my Step pin and 1 as my direction pin with Dir. Low Active enabled.  Under Spindle Setup, I have Use Spindle Motor Output enabled with Step/Dir. control enabled.  I have Relay enabled with output #1.  Under Output Signals I have Output #1 set for pin 1.  

Are things wired correctly and do I have the proper settings?  Any help would be greatly appreciated

Pages: 1