Hello Guest it is July 22, 2019, 05:18:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MAT

Pages: 1
1
Galil / Re: Galil card not connected
« on: July 01, 2010, 05:07:04 PM »
Hi Flipz01,


You must use SmartTerm. This software is available on galil web site in download section. After that, you can fellow instructions in pdf file coming with the plug-in (http://www.machsupport.com/plugins/GalilPlugIn.pdf).

Mat

2
Galil / Re: Galil dmc1425 doGmove issue
« on: June 29, 2010, 08:28:58 AM »
Moreover, I check in galildebug file. When we ask a G move in programmed mode, no command was save in debug file. It is for this reason than we search for buffer size problem.

MAT

3
Galil / Galil dmc1425 doGmove issue
« on: June 29, 2010, 08:19:24 AM »
I use a dmc1425 with servo motor for a xy table. I try to use MACH3 and the plug-in (lastest version) to control this table . But, the plug-in doesn't work with 1425 properly. In fact, just the continuous jog mode work. My representative try plug-in with a dmc2123 and it work properly. With same settings, his 1425 does't work. We ask to Galil the difference between this two type of controller and the most important is the size of buffer. The 2123 has 511 lines and the 1425 only 255. I check the galilcontrol.cpp file in sdk folder and I think that's why the plug-in does't work with 1425. Unfortunately, I don't have visual studio to compile code.

Thanks a lot


4
Galil / Re: Galil + Mach issue with G moves
« on: June 28, 2010, 08:45:31 AM »
Hi,

I have same kind of issue with dmc-1425 galil controler. In continuous mode, the DRO work well. But, when I use step mode with 1" increment, the "to go" set at 0,999" and noting move. Then, I can't move my axis in continuous mode without a Reset. I observed same behavior when I try a G1X1 in MDI screen. I use the lastest version of MACH and galil plug-in is 4.4 .

Thanks a lot for your help.

Pages: 1