Hello Guest it is March 28, 2024, 02:10:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - piperman

Pages: 1
1
Mach4 General Discussion / Re: RhinoCAM turning post processor for MACH4
« on: February 24, 2020, 05:07:31 AM »
Hi Steve,

 Thank you so much for your reply. I will go ahead and use the Fanuc post processor and see how I get on. Cheers

2
Mach4 General Discussion / RhinoCAM turning post processor for MACH4
« on: February 23, 2020, 06:19:19 PM »
Hi Everyone, I am sure someone else has asked this but I can't find any post regarding this. I am having another go at getting my Sherline lathe up and running. I tried a few years ago to no avail and gave up in the end. I have a new computer loaded with MACH4 all set up to plugin and go. I am looking at getting RhinoCAM as I am proficient with Rhino. I noticed on the MecSoft website that there is no post processor for MACH4. Does anyone know if another post processor will work or if someone has written one?  Any help will be truly appreciated.  Cheers Shane

Pages: 1