1
General Mach Discussion / digitizing
« on: December 01, 2012, 08:33:23 PM »
I am just beginning the digitizing probe (duplicating) learning curve.
I have been scouring the forums and have seen CopyCat mentioned
I have people asking me to duplicate existing and or make new handgun grips.
I know mach 3.042.040 has a digitizing wizard, but is that the best wizard for duplicating?
I need to first map the outline, then the contours.
Ideally, I would like to digitize a part and import to Aspire to tweak contouring.
Any assistance is appreciated !!!!
I have been scouring the forums and have seen CopyCat mentioned
I have people asking me to duplicate existing and or make new handgun grips.
I know mach 3.042.040 has a digitizing wizard, but is that the best wizard for duplicating?
I need to first map the outline, then the contours.
Ideally, I would like to digitize a part and import to Aspire to tweak contouring.
Any assistance is appreciated !!!!