Hello Guest it is March 29, 2024, 03:38:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jdzyne

Pages: 1
1
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: August 03, 2010, 11:40:44 AM »
Hey Hood... thanks for all of your help..
I got it to work finally.
The key were the outputs...

thanks again!

J

2
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 28, 2010, 07:13:36 PM »
Ok... after tuning the motor etc...
Nothing!!!
I have found I have Sound Logic breakout board with
a parallel relay board, as well as a speed board...
along with automation direct Freq drive GS2, 22PO
And I just can't figure out why it will work with 2 and not 3

Shoot me in the head please!!!!

3
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 26, 2010, 10:43:32 PM »
tried that.... nothing
i go back into Mach 2... no problems??

i have tried everything i can find... it's like there is no switch or something..
the drives, controllers etc are gecko G320, the system as best i can tell..
is from Automation direct...
a GS2-22PO freq. drive.. servo motors..
motor is AC


I have to be missing something...
The only other thing i can say... is when you hit the E stop on the screen in Mach 2...the machine makes a sound..it sounds "right"....
in Mach three, it makes a similar sound... but it doesn't sound right...

4
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 26, 2010, 07:32:52 PM »
i have gotten the xyz to work, but not the Spindle

5
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 24, 2010, 04:05:58 PM »
thank you... hopefully i can figure this out!!!

6
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 24, 2010, 04:02:14 PM »
i guess not!
i do have #1 and #2 set just like it was on MACH 2...

7
General Mach Discussion / Newbie Needs HELP!!!
« on: July 24, 2010, 03:41:28 PM »
I recently purchased a machine built by "CNC Tools & Machinery" which is no longer in business..
The machine does not appear to have ever cut a part, and seems to be built very well.
     It is a converted RF45, to servos, 2hp frq dr, etc...  It came with a liscensed version of Mach2.
I finally got it to run... using an old HP laptop which has a parallel port... Then I upgraded it to Mach 3,
now nothing... doesn't even recognize it at all??

I guess i am retarded!!!

Any ideas?

8
Hello All,
             I am new user... overwhelmingly frustrated... but excited to learn all of this nonetheless!
I recently purchased a machine built by "CNC Tools & Machinery" which is no longer in business..
The machine does not appear to have ever cut a part, and seems to be built very well.
     It is a converted RF45, to servos, 2hp frq dr, etc...  It came with a liscensed version of Mach2.
I finally got it to run... using an old HP laptop which has a parallel port... Then I upgraded it to Mach 3,
now nothing... doesn;t even recognize it at all??

I guess i am retarded!!!

Pages: 1