Hello Guest it is November 21, 2019, 06:59:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - timskx1

Pages: 1 2 »
1
General Mach Discussion / Re: Setup units
« on: November 23, 2010, 12:11:54 PM »
I am at work, and my machine is at home  i will try and post it later or if not  tomorrow

2
General Mach Discussion / Re: Setup units
« on: November 23, 2010, 11:57:20 AM »
i did try to use the G code, but the machine still only moves in metric

3
General Mach Discussion / Re: Setup units
« on: November 23, 2010, 09:54:27 AM »
is that the only way to get the machine to run in inches?

4
Hi my name is Tim.  I know it can be done.  I have a Siege kx1, and it comes with 2 set profiles.  one for kx1, and one for kx3.  I am not sure how it is done though, as i have only Had the machine and experience with mach 3 for a few weeks.

6
I am using the configuration that came with the cnc when  i bought it.  Seige KX1

7
I am not in front of the computer with the mach 3 software on it.  That comp is at home.  If i get a chance tonight i will copy it to a flash drive and bring it in tomorrow.  Thanks

9
Hi everyone.  Tim here.  I am having a problem with the units on my mach 3 software.  I set it ti inches, but the machine is working in metric units still.  anyone have any idea what is going on?  Thanks all.

Pages: 1 2 »