Messages

1

General Mach Discussion / Mach3 ESS Issue with getting the motors to turn

« on: July 12, 2023, 12:49:01 PM »

Hi looking for some help. My machine home build has been working fine until a window upgrade was accidently done. I reestablished communication to the ESS through the windows firewall. All good there, ESS communicating well but my motors would not run. I can switch relays off and on in the box with the Mach3 SOFTWARE. i Noted the output LED on the C11G was not on so I changed out and put in a new  C11G BOB wiring the motors back exactly in the same configuration. The new C11G BOB show red LED light on the motor out put direction and Puls pins. I still cannot get the motors to turn. When I activate the X or Y axis I see the axis change in the display but there is no action on the motors. At a loss to explain next step is to get a new ESS?

2

G-Code, CAD, and CAM discussions / Re: All I have is G-code, help with approach to make mods

« on: March 28, 2011, 09:33:27 PM »

Hi I am planning to do this from scratch....I have built a good machine that works well and started thinking about building guitars... I am pretty ok with BOBCAD CAM and MACH3... Maybe we can talk