Messages

1

General Mach Discussion / Re: loss of control

« on: May 13, 2010, 01:18:59 PM »

Thanks for the advise.

I tried using the restore button, which reboots the computor. When I bring it up, the reset light is flashing. I click on the the reset button, but it will not reset. I tried pushing in the red emergency stop button, but that did not help either.

2

General Mach Discussion / loss of control

« on: May 12, 2010, 06:36:24 PM »

I installed Mach3, ran through the conconfiguration to get it set up and everything worked great. Then I loaded Bobcad  into the computor. I designed a part, converted it to gcode and tried to start the mill when I found out that it no longer worked. The X Y &Z all seem to be loaded in the same port. the X axis goes in the same direction regardless if I manually press left or right, the y axis only works when I press the Z key.
Did the computor reconfigure itself? Help!!!