Messages

1

General Mach Discussion / Re: drives will not reverse

« on: October 24, 2011, 03:42:27 PM »

Thanks for the help... It worked.  I changed the wires on BOB for the X dr.  from  2 and 3   to  8 and 9

2

General Mach Discussion / Re: drives will not reverse

« on: October 23, 2011, 06:02:27 PM »

I have all axis working in both directions Now ..except the X  axis.     I have checked and rechecked ports and pins setup  and  all checked to specs.  I was wondering if one wire is wrong on the bob. It maybe something simple.  Help

3

General Mach Discussion / drives will not reverse

« on: October 23, 2011, 01:45:30 PM »

I can jog in one direction only.  I replaced the BOB (DB25) recently and i also replaced my computer because the mother board was fried..  The Y  would reverse for a while   but when I made some changes it will work only one way now.  All seems ok in the program but may not be.  Help  Help