Hello Guest it is September 19, 2019, 02:35:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Spike

Pages: 1
1
General Mach Discussion / Re: charge pump
« on: May 09, 2010, 12:19:14 PM »
Thanks for your speedy answer and your advice. However the confusion arises from the fact that in the manual, the signal from the charge pump goes direct into the hex inverter 7406 without showing any timing circuitry as you indicated.

Spike

2
General Mach Discussion / charge pump
« on: May 05, 2010, 02:53:10 AM »
Hi there I'm new in this field. Can i use the 12.5 kHz signal as is or must I add any special circuit to drive the relais?
Spike

Pages: 1