Hello Guest it is August 08, 2020, 03:12:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jnida63

Pages: 1
1
General Mach Discussion / Re: Y axis help
« on: March 27, 2012, 09:09:05 PM »
Well, i am not very well versed in Mach as you can tell, I can't get it right. It just keeps on moving my work farther out on the table.
Guess I will keep doing it the long way.

2
General Mach Discussion / Re: Y axis help
« on: March 27, 2012, 06:10:54 PM »
What works is it homes in the center of the Y axis but still only cuts to one side, it basically moves my cnc file over 11 inches, i want to the Y to move left and right of the 11 inch mark, not move the work further out on the table

3
General Mach Discussion / Re: Y axis help
« on: March 27, 2012, 06:41:58 AM »
Well that works for setting it up at zero but will not let me cut on the negative side and smashes the gantry against the limit switch, i just want to start the cut in the center of the y, not move the work farther on my table

4
General Mach Discussion / Y axis help
« on: March 25, 2012, 12:28:14 AM »
I have a 24 X 48 mill with a safe working area of 22 X 44, what I am trying to do it to start my cuts at 11 inches on the Y axis to make it easier to cut 2 sided files, I would like to set the home at 11 inches on the Y axis but am unsure how to set mach up to do this.
This way i can mark the center of the piece i am cutting and can just flip it over to do the backside.
Any help would be appreciated

Pages: 1