Messages

1

General Mach Discussion / Probe Installation Problems!!!!!!!!!

« on: March 26, 2010, 09:29:17 AM »

Hello I need help and was wondering if any one has installed successfully a Econo-Probe 3D probe tool http://www.wildhorse-innovations.com/index.php?_a=viewProd&productId=80.  I tried to install it on my mach 3 system ver.R3.042.029 using the port 2 pin 15 and then going to ports and pins and set up it up.  Tried doing Digitizing program dosen't work tried fin the edge nothing.  The people from wildhorse inovations said this probe acts like a normally closed switch when touch it opens.  Really don't know if my connection is the problem or the program in mach 3 is not configured correctly?  If any body can lend me a hand it would be great thanks.