Messages

1

General Mach Discussion / Re: touch probe file converting to g gode??

« on: January 19, 2011, 10:43:52 PM »

Hi Out their , Can anyone tell me how to retrieve the probe setup, in Mach3 !   I looked at the tutiral for Mach3 ! 
opened up ,operator , scroled down to ,VB Script Editor, clicked it and opened up folder in that window , could not find the PROBE listing like in the tutiral for Mach3!!  ?    ANY Help    THANKS

2

General Mach Discussion / Re: Jerky motor rotation HELP

« on: April 05, 2010, 11:11:54 AM »

Hi can anyone tell me what sofrware I should use to run a router that has 3 
motors ,23D-6204H 4.3 VDC 1.8 A/O
I have a FET3 board I think I have the wires hooked up right ! I have a
cherokee 150 watt switching DC power supply, hooked up , I have the parell port
hooked up to my computer !! Now hears my problem, What do I do now ! All the
software that came with the router were lost about 6 years ago, I've seen the
router run! but not with this setup! OK what do I do now ! any one THANKS
router size is 18"X 20" Any information on how to go from my computer to the
motors and run or jogg them,I'am lost thanks for any help

3

General Mach Discussion / Re: Jerky motor rotation HELP

« on: April 04, 2010, 10:37:19 PM »

Hi can anyone tell me what sofrware I should use to run a router that has 3
motors
,23D-6204H 4.3 VDC 1.8 A/O
I have a FET3 board I think I have the wires hooked up right ! I have a
cherokee 150 watt switching DC power supply, hooked up , I have the parell port
hooked up to my computer !! Now hears my problem, What do I do now ! All the
software that came with the router were lost about 6 years ago, I've seen the
router run! but not with this setup! OK what do I do now ! any one THANKS
router size is 18"X 20" Any information on how to go from my computer to the
motors and run or jogg them,I'am lost thanks for any help