Hello Guest it is April 10, 2021, 09:13:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jnneric

Pages: 1
1
General Mach Discussion / Re: machine keeps stopping
« on: March 25, 2010, 08:39:19 PM »
i will see if i can find my camera,  there are 5 switches total   one on each end of the x and y screws and one one the top of the z, don't know if they are limit or home , maybe 1 home for x and one home for y  and the other 3 are limit,  but i really don't know for sure. and i am assuming that the breakout board is in the control box? is that right?

2
General Mach Discussion / Re: machine keeps stopping
« on: March 25, 2010, 07:22:56 PM »
hello,  sorry for my ignorance ,  but i really don't know,  but if you tell me how to check i will do so.

3
General Mach Discussion / Re: machine keeps stopping
« on: March 25, 2010, 01:28:43 PM »
here is my xml file ,  thank you for looking at it for me

4
General Mach Discussion / machine keeps stopping
« on: March 24, 2010, 09:25:13 PM »
hello all,   I am new to cnc ,  I have a 20"x20" router and everything works great except the machine keeps stopping for no apparent reason,  I am using a rotozip for a router and it stops too.  everything restarts when i reset the estop on screen (no actual button) , restart the router , and hit "run" and she continues right on from where she stopped,  this is terribly inconvenient,  don't know what to do or where to start , and one more thing ,  in the diagnostic screen the m1++ is yellow but goes out when i manually engage the switch


HELP ME MISTER WIZZARD ! ???

5
Mach3 and G-Rex / machine keeps stopping
« on: March 21, 2010, 10:14:05 PM »
hello all,   I am new to cnc ,  I have a 20"x20" router and everything works great except the machine keeps stopping for no apparent reason,  I am using a rotozip for a router and it stops too.  everything restarts when i reset the estop on screen (no actual button) , restart the router , and hit "run" and she continues right on from where she stopped,  this is terribly inconvenient,  don't know what to do or where to start , and one more thing ,  in the diagnostic screen the m1++ is yellow but goes out when i manually engage the switch


HELP ME MISTER WIZZARD !

Pages: 1