Messages

1

Mach SDK plugin questions and answers. / Re: PowerMate Plugin

« on: April 14, 2010, 11:34:02 AM »

I got so frustrated....I just went out and got the PC version of the XBOX 360
controler and that works very well.
I dis have the Registered version  of Mach 3.

Thanks
for the Reply

2

Mach SDK plugin questions and answers. / Re: PowerMate Plugin

« on: March 25, 2010, 05:35:23 PM »

I have the Same Problem.....
So I have wasted $45.00 and about 4 hours of time because someone did not know that this
Plug-In is not for a PC......

That is not a good thing since it seams to have been in the plug-in download
page for a long long time.....

Any MAC users out there want to buy a Brand New Griffin Powermate For half Price....
Whoever runs the Artsoft Site needs to Clarify that this Plug-In does not work....OR make it work...

Joe

3

FAQs / Please Help with Powermate

« on: March 19, 2010, 03:56:16 PM »

Hi went to the Artsoft site and while looking under Plug-Ins
I found the griffin powermate plug-in download.
I read the description of the unit and spent the $45.00 and ordered it.
I have it now and it does not seam to work......
I am running Version R3.042.038 of Mach 3.....
I downloaded the Griffin Powermate Plug-in Version 2.00.046 by Art Fenerty.
In the Program Run Tab on the standard screenset at the lower left corner
in the Status Window, when I press down on the Powermate it displays the
axis rotation but nothing happens at the table......
I am hoping that someone here can help me figure this out so I did not
waste my time and effort and dollars to use the Powermate suggested in the Plug-In page @ Artsoft.
Any Help would be awesome.

Thanks
Joe

4

General Mach Discussion / Griffin Powermate

« on: March 17, 2010, 07:14:48 PM »

Hi went to the Artsoft site and while looking under Plug-Ins
I found the griffin powermate plug-in download.
I read the description of the unit and spent the $45.00 and ordered it.
I have it now and it does not seam to work......
I am running Version R3.042.038 of Mach 3.....
I downloaded the Griffin Powermate Plug-in Version 2.00.046 by Art Fenerty.
In the Program Run Tab on the standard screenset at the lower left corner
in the Status Window, when I press down on the Powermate it displays the
axis rotation but nothing happens at the table......
I am hoping that someone here can help me figure this out so I did not
waste my time and effort and dollars to use the Powermate suggested in the Plug-In page @ Artsoft.
Any Help would be awesome.

Thanks
Joe