Messages

1

General Mach Discussion / need a macro for "temp" slaved axis/asap

« on: April 08, 2007, 08:38:35 PM »

  I need a function [macro] that will temporarily   slave my A axis[spindle#2] to my Z axis[spindle1]
     Art suggested I slave C to Z in cfg,then write a Macro to swap C&A , and then a macro[another one?] to cancel the swap.

    I searched all over for an oem  code for "swapaxis" but it must not exist.
 
   I could sweat blood for days trying to learn VB and writing macros to do what one of you guys could whip out in a matter of minutes
                      OR
   I can go make parts[what I know] and  PAY  $$  someone who knows this stuff.     

  best to contact me at  carlcnc@yahoo.com

 thanks
Carl

2

General Mach Discussion / Re: Help! Please! this Chaos has to stop!

« on: December 12, 2006, 04:57:12 PM »

Just a thought,
Greg are you using the on-board video output??  This can cause interrupts in Mach3's pulse outputs,,even an old 8meg  will operate for MAch3.
 
have you "optimised" XP for Mach3 ?? I am surprised no one asked these questions yet
  good luck
Carl