Hello Guest it is March 28, 2024, 10:57:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tjstamp

Pages: 1 2 3 4 5 6 7 8 »
1
General Mach Discussion / Z axis problems.
« on: September 28, 2019, 06:06:11 PM »
what would cause the z axis to not respond properly. sometimes it stays up and other times it goes down. thinking it is not getting the steps correct.

2
Share Your GCode / Re: Chucks Deer V carve engraving
« on: November 21, 2017, 06:44:26 AM »
I just used it on a sign I made for a friend.

3
Share Your GCode / Re: Can't Fix Stupid Video and File
« on: February 12, 2017, 01:27:41 PM »
THIS IS THE DXF I MADE FOR CAN'T FIX STUPID.

4
Share Your GCode / Re: Can't Fix Stupid Video and File
« on: February 12, 2017, 01:03:26 PM »
thanks for the reply. I used that function once but I needed it (DXF) so I could bring it down some. my machine max is only Y-20 X-40.

5
Share Your GCode / Re: Can't Fix Stupid Video and File
« on: February 11, 2017, 07:52:41 AM »
I don't know what I was thinking. I did run your code in Mach 3 and all is well. I just drew it out in Bob-Cad as dxf so the size could be tweaked. thanks.

6
G-Code, CAD, and CAM discussions / Re: F-Engrave.
« on: January 12, 2017, 12:41:41 PM »
great program.

7
Share Your GCode / Re: Can't Fix Stupid Video and File
« on: January 07, 2017, 03:54:38 PM »
thanks for the reply. can't use the file tho. I have BoB-Cad and use Fanuc G-Code. i'll getter done tho. :)

8
Share Your GCode / Re: Can't Fix Stupid Video and File
« on: January 06, 2017, 02:48:49 PM »
what is the board size and where did you "o" at? center lower left.

9
Share Your GCode / Re: Chucks Deer V carve engraving
« on: January 01, 2014, 08:48:00 AM »
I noticed a few have down loaded the dxf's that I put up. that's cool cause I got a lot of help from this forum. just giving back what I can.



10
Share Your GCode / Re: Chucks Deer V carve engraving
« on: December 27, 2013, 05:14:11 PM »
heres a good one. dxf

Pages: 1 2 3 4 5 6 7 8 »