Messages

1

General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver

« on: March 03, 2010, 08:48:53 PM »

The engraver came today and it appears to be in working order. But it has no manual so I'm not sure what commands are used to control it. I played with it alittle and can get it to go into the progam but can't get it to let me imput any numbers. So if anyone hase a manual for a vanguard 3000 that  I could copy I would pay for it. Thanks Gary

2

General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver

« on: March 01, 2010, 11:07:45 PM »

Thanks xray I am goiing to contact zarzul I haven't eveb gotten the engraver yet it is still enrout I appriciate all of your input. I was told that the controller that it came with still works but it willbe nice to up grade so I don't have to worry about it. IU am going to use it primarily to make I D tags for employees and for plant Idetification I own a garden center and we have a lot of display gardens that I wantto label alll the plants in. Thanks again ffor the input

Gary

3

General Mach Discussion / Re: Controller for New Hermes Vanguard 3000 Engraver

« on: February 28, 2010, 08:04:41 PM »

Xray Do any of you do this upgrade for us as I am not that good with circuit boards. I purchased a vanguard 3000 on ebay and would like  to upgradeit if possible