Hello Guest it is April 11, 2021, 09:10:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kn63988

Pages: 1
1
General Mach Discussion / Re: Help Can't Jog anymore
« on: March 23, 2013, 07:26:37 PM »
Nevermind I solve the problem. For some reason all my output motor pin was disabled..

Thanks anyway...

2
General Mach Discussion / Help Can't Jog anymore
« on: March 23, 2013, 07:15:06 PM »
Yesterday my cnc router was working just fine.. all of a suddenly today I can't jog any more. When I click on the arrow key on my keyboard the X-Y coordinate does not move in mach3.
I went ahead and loaded one of my gcode file anyway to see if it still run. Once loaded and click on run it turn on my router and then shut off immediately.

The only thing I know I mess with was I disabled the pin for X++,X- -,X home because I was having issue with the limit switch. I have been running like that for week now so I know it is not the cause of it.

One thing I did notice that is very odd was on the "Motor Tuning and setup". All of the Axis on the right side are all greyed out. I can't make changes to any of the axis except the X-axis

Anybody have any ideal what the issue is? I might of change something by mistake and need some help pointing me to the right direction..

Thanks

Pages: 1