Messages

1

General Mach Discussion / Re: STM23 Series stepmotors compatible with mach 3

« on: February 25, 2010, 03:53:16 PM »

this is input characteristic

STEP+/-
Optically Isolated, 5-24 Volt. Minimum pulse width = 250 ns. Maximum pulse frequency = 3MHz
Function: Step, CW Step, A Quadrature, Encoder Following, CW Limit, CW Jog, Start/Stop (Oscillator mode), general purpose

DIR+/-
Optically Isolated, 5-24 Volt. Minimum pulse width = 250 ns. Maximum pulse frequency = 3 MHz
Function: Direction, CCW Step, B Quadrature, Encoder Following, CCW Limit , CCW Jog, Direction (Oscillator mode), general purpose

EN+/-
Optically Isolated, 5-24 Volt. Minimum pulse width = 250 ns. Maximum pulse frequency = 3 MHz
Function: Enable, Alarm Reset, Speed 1/Speed 2 (Oscillator), general purpose


i think we are ok??? if yes ill start the construction!,
thanks

2

General Mach Discussion / STM23 Series stepmotors compatible with mach 3

« on: February 25, 2010, 03:28:35 PM »

hello I'm new in mach 3
i wand to build a cnc using the STM23 Series of the www.applied-motion.com that i allready have available!!
this motors have a steeper controller on board! can i use this motors with mach3??

thanks and sorry for my bad English!