Hello Guest it is March 29, 2024, 01:34:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bazzag

Pages: 1
1
VB and the development of wizards / Mach 3 Turn Wizards
« on: February 22, 2010, 04:35:49 AM »
Just started using Mach3 on a CNC lathe. I am having problems when running G Code created using the lathe turning wizards. I have found that the M3 generated by the wizard does not activate the dwell I have set for the spindle and the spindle eventually stops during execution of the G Code. If I edit the M3 to M4 and save the G Code, eveything runs as expected.
Anyone experienced this or have any clues to what is going on.

Bazzag

Pages: 1