1
General Mach Discussion / Re: Need a recommendation for control board for plasma cutter.
« on: June 29, 2021, 12:21:47 PM »
Hi Craig,
I've decided to go with the ethernet Smooth Stepper along with the C25 BOB. It seemed like the easiest solution and easiest to connect.
The last question I have is your comment about Mach 4 being a poor choice for the Proma but still suggesting I switch to Mach 4. Is the anti-dive feature worth the Proma issue?
Again, thanks for the help.
Tom
I've decided to go with the ethernet Smooth Stepper along with the C25 BOB. It seemed like the easiest solution and easiest to connect.
The last question I have is your comment about Mach 4 being a poor choice for the Proma but still suggesting I switch to Mach 4. Is the anti-dive feature worth the Proma issue?
Again, thanks for the help.
Tom