1
General Mach Discussion / Re: Set up and configuration???
« on: February 04, 2010, 11:20:37 AM »
The co-ordinates i need are machine coordinates. my vice is in the exact same position as when i used PCNC but the tool ends up in a different place than it should...
when i started up Mach 3, i clicked "Ref All Home" and that brought me to my home park position of 0,0,0 i wasnt able to compare this to my previous park position as i didnt have it marked on my vice, it was only when i went to move to above my starting point i noticed the difference.
i cant think of anything that it could be, except a software difference? or how its calibrated?
when i started up Mach 3, i clicked "Ref All Home" and that brought me to my home park position of 0,0,0 i wasnt able to compare this to my previous park position as i didnt have it marked on my vice, it was only when i went to move to above my starting point i noticed the difference.
i cant think of anything that it could be, except a software difference? or how its calibrated?