Hello Guest it is March 29, 2024, 04:13:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CINENAUT

Pages: 1
1
General Mach Discussion / Re: Motor and driver problems. Please HELP
« on: January 14, 2010, 01:58:39 AM »
Yes, thank you this is my first post. I have a metal shop in Thousand Oaks CA. Just bought a used router table (not working) and trying to get it operational.  The motors appear to be uni-polar (6 wire). The drivers are old but am told they are working. They have built-in power supply. I have the documentation for the drivers. There is a "RUN" potentiometer and a "STOP" potentiometer on the drivers. There are also "+" and "-" terminals for step and direction. Right now I have the step  "+" wired to pin 2 and dir. wired to pin 6 (X axis) and "-" wired to the COM pin with both "-" terminals jumpered. I am running Mach 3 through a CNC4PC C10 breakout board. The motors are responding to the up & down arrow keys. The documentation describes the symptoms I'm experiencing and suggests to change the signal timing. Not sure how to do this. By the way, I have 3 matching motors and 3 matching drivers.

Thanks,
Randy

2
General Mach Discussion / Re: Motor and driver problems. Please HELP
« on: January 13, 2010, 07:12:42 PM »
Having similar problem with Slo-Syn M063-F-S-402B and Super Vexta UDX2140A Drivers. Have you solved it yet?

Pages: 1