Hello Guest it is December 09, 2021, 03:47:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Steven

Pages: 1
1
General Mach Discussion / Need advice
« on: January 09, 2010, 05:40:44 AM »
  I am in the process or building a new Router and plan on using Mach3 as my control software. For the last few years I have been using another control software so I will be learning to use Mach3 from scratch.  I will need to write some macros for some of the things I want to do and from what I've learned from reading through this forum is that there is a newer version of Mach3 in the works that is supposedly going to either make writing macros easier or differently somehow.
  If this is the case, Is it going to be worth the time spent learning how to write macros in the form they are currently used or will I be spending my time trying to learn something that is soon to become obsolete? I don't have any programming experience in VB but I have done quite a bit with C++ although it's been a few years.
 It will be a few months before I'm ready to make chips with the new router so I'm in no rush to get any macros written but would like to experiment a little until then.

Thanks.

Pages: 1