Hello Guest it is August 08, 2020, 11:32:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kkin

Pages: 1
1
My name is Kane

I am new to this form and I am working on and three axes mill.
I have mach3 software and a HobbyCNC EZ Driver Board
Frame size: NEMA 23
Holding torque: 136 oz-in
Voltage: 3.2 VDC
Current: 2 A
Step Angle: 1.8° (200 steps/rev)
Leads: 6 wires
Wiring: Unipolar
stepper motors
And I could use a lot of help to create and configuration file
 I have a lot to learn?

Thank you for reading Kane

Pages: 1