Messages

1

General Mach Discussion / Re: Calling all post processors. ( Help me to help you )

« on: January 03, 2010, 10:24:34 PM »

I think I do have a postprocessor I just don't know how to make it work. Sometimes I can get a G code into Mach3 with LazyCAM but it won't run. I can' t get anything from Countour cam. The default processor is FANUC.

2

General Mach Discussion / Re: Calling all post processors. ( Help me to help you )

« on: January 03, 2010, 09:00:02 PM »

I think I do have a postprocessor I just don't know how to make it work. Sometimes I can get a G code into Mach3 with LazyCAM but it won't run. I can' t get anything from Countour cam. The default processor is FANUC.

I guess I will reread the maunal and keep playing around with it.

3

General Mach Discussion / Re: Calling all post processors. ( Help me to help you )

« on: January 02, 2010, 02:38:07 PM »

I have CountourCAM,Lazycam, and mache3. Do need to buy a post processor?

4

FAQs / Re: ellipse

« on: December 26, 2009, 06:23:45 PM »

 :)Thanks a lot. Ellipse worked out great even though I forgot to tell you the tool dia. It dosen't matter if it is a bit smaller.
This a wonderfull group. I hope the day comes when I can help some of you.

5

FAQs / ellipse

« on: December 26, 2009, 12:27:30 AM »

I need to make an ellipse from .125 brass. 1.6 long .800 wide The wizard in Mach3 dosen't work. There is a picture of one in Lazycam, I think it is in Paint I can't do anything with it. Can anybody help me out?