1
General Mach Discussion / Re: verifyaxis macro only moves z-axis
« on: December 25, 2009, 04:41:44 AM »
I am using the actual Mach version with the Smothstepper. It seem to be the same fault, that Russ describes when simulating Mach3 without PP driver.
May be a macro with three "singleverify" commands for each axis will work. I will try this later, but I am not experienced in writing macros...
Regards
Tino
May be a macro with three "singleverify" commands for each axis will work. I will try this later, but I am not experienced in writing macros...
Regards
Tino