1
General Mach Discussion / Re: EMCO PC Mill and Turn 55 - Conversion
« on: February 11, 2011, 11:21:42 AM »
I see where you posted some information on the Emco thread over at the c-n-c zone. Buried in that thread on page 10 is where we retrofitted a pc mill last year. Honestly, it was one of the easiest retrofits we have ever done requiring only to drill out a few holes in the mounting plates and pulleys. Here is the single-post link:
http://www.cnczone.com/forums/763694-post106.html
http://www.cnczone.com/forums/763694-post106.html